GET STARTED

Open your drawing.

Import an SVG to review its colors and operations.

Source file

SVG

Page settings

1 page

Width (mm)

Height (mm)

Applies to all pages. Drawing size and position stay unchanged.

Show 290 × 290 mm guide

· 5 mm inset

Automatic layout

Minimum spacing (mm) Edge margin (mm)

Inset from every page edge, shown by the blue dashed guide. Applied when you accept a suggested layout, even when the guide is hidden.

Part rotation No rotationKeep each part at its current angle. 90° stepsTry 0°, 90°, 180° and 270° from the current angle.

Keeps the selected edge margin, even when the guide is hidden. Keeps parts intact; leaves holes empty unless Fill closed holes is enabled. Matching and mirrored parts are kept near each other where possible.

Fill closed holes

One level of nested parts. Adds automatic tabs to the nested parts, occupied holes and host outlines so the set stays attached to the sheet. Enables Tabs when needed. The complete set moves together. Review before applying; Undo restores the previous layout.

Detect parts first to arrange them on pages.

Export one combined SVG or a ZIP with one SVG per page. Borders and guides are never exported.

Tabs / bridges Off

Enable tabs Tab size (mm)

Length skipped by the laser, after kerf. Turning tabs off keeps their positions.

Engrave tabs

Automatic placement

Placement method

Tabs per shape

Skip inner shapes Include outer frames

Parts inside a frame get their own tabs. Outer frames are skipped by default; existing manual tabs stay.

Outer frames

Possible frames are suggestions. Outlines stay material until you choose Outer frame. Confirmed choices affect part recognition, kerf and automatic tabs.

One tab on small shapes

Perimeter up to (mm)

One tab at or below this limit, overriding count or spacing. Measured after scale and kerf. Existing manual tabs stay.

Add tabs on large shapes

Target spacing (mm)

Keep at least Tabs per shape. Add more when perimeter ÷ target spacing needs a higher count, rounded up. Measured along each closed outline after scale and kerf; hole lengths are not added to the outer perimeter. The small-shape rule takes priority. Manual tabs count toward the total. Positions may shift to avoid corners and slots.

Tabs prefer opposing pairs on straight sides; an odd tab fills the remaining space. Two tabs on a long body prefer its middle when clear edges are available. Prefers 3 mm from inward corners and 2 mm from rounded corners. If no regular location fits, reduces corner spacing automatically, down to 0.1 mm, keeping the tab size. Always keeps 3 mm from open cuts and avoids slot walls. Complete circles and regular toothed wheels can use curved edges; wheel tabs stay on tooth crowns.

All eligible closed Cut outlines. Manual tabs count toward the total and stay in place.

Replaces previous automatic tabs. Moved tabs become manual. Undo restores the previous placement.

Click an outline to add. Drag a red dot to move. Double-click or Shift-click a dot to remove. Closed Cut outlines and holes only.

FROM DRAWING TO CUT

Start with your SVG.

Drop a file to inspect its size, paths and colors.
Your drawing stays on this device.

SVG paths & shapes · up to 20 MB

Start with your SVG.

Export drawing

Keep your project changes?

Suggested layout

Convert text to curves